Home>ISO Standards>ISO 52017-1:2017 pdf free

ISO 52017-1:2017 pdf free

ISO 52017-1:2017 pdf free.Energy performance of buildings一Sensible and latent heat loads and internal temperatures
This document specifies the general assumptions, boundary conditions and equations for the calculation, under transient hourly or subhourly conditions, of the internal temperatures (air and operative) and/or the heating, cooling and humidification and dehumidification loads to hold a specific (temperature, moisture) set point, in a single building zone. No specific numerical techniques are imposed by this document.
Specific calculation procedures based on the generic calculation procedures of this document are given in ISO 52016-1. The specific simplifications, assumptions and boundary conditions in ISO 52016-1 are tailored to the respective application areas, such as the energy need for heating and cooling and for humidification and dehumidification, hourly internal temperature, design heating and cooling and humidification and dehumidification load.
NOTE Table 1 in the Introduction shows the relative position of this document within the set of EPB standards in the context of the modular structure as set out in ISO 52000-1.
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 7345, Thermal insulation一Physical quantities and definitions
ISO 13370, Thermal performance of buildings一Heat transfer via the ground一Calculation methods
ISO 52000-1:2017, Energy performance of building一Overarching EPB assessment 一Part 1: General framework and procedures
ISO 52010-1, Energy performance of buildings一External climatic conditions 一Part 1: Conversion of climatic data for energy calculations
ISO 52016-1, Energy performance of buildings 一Energy needs for heating and cooling, internal temperatures and sensible and latent heat loads一Part 1: Calculation procedures
NOTE 1 Default references to EPB standards other than ISO 52000-1 are identified by the EPB module code number and given in Annex A (normative template in Table A.1) and Annex B (informative default choice in Table B.1).
NOTE 2 In this document, there are no choices in references to other EPB standards. The sentence and note above is kept to maintain uniformity between all EPB standards.ISO 52017-1 pdf download.

Related standards