Home>ISO Standards>ISO 3040:2016 pdf free

ISO 3040:2016 pdf free

ISO 3040:2016 pdf free.Geometrical product specifications (GPS)一Dimensioning and tolerancing一Cones
ISO 3040 specifies graphical indication applicable to a cone (right-angle circular cones) to define its dimensioning or to specify its tolerancing.
For the purposes of this International Standard, the term“cone” relates to right-angle circular cones only (any intersection by a plane perpendicular to the axis of the nominal cone is a circle).
NOTE 1 For simplicity, only truncated cones have been represented in this International Standard. However,this International Standard can be applied to any type of cone within its scope.
NOTE 2 This International Standard is not intended to prevent the use of other methods of dimensioning and tolerancing.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 1119:2011, Geometrical product specifications (GPS)一Series of conical tapers and taper angles
ISO 81714-1, Design of graphical symbols for use in the technical documentation of products一Part 1:Basic rules
The set of degrees of freedom, which are possible to consider individually or collectively, is:
一the angle deviation;
一the form deviation on a section line or the surface;
一the location deviation (X, Y, Z: in Cartesian system);
一the orientation deviation ( γ : in Cartesian system).
The table in Eigure 11 presents, for a specification, the type of deviations which are controlled.
The indication of the specification is presented and its meaning is illustrated and explained. This presentation is used in Annex A.
Figure 11 and Annex A present various individual (independent) examples of possible dimensional or geometrical specifications in relation with a cone, in accordance with ISO 1101, ISO 14405-1 and ISO 14405-3. Each of these examples shall be considered independently from each other, but could be used in the same drawing on the same feature.ISO 3040 pdf download.

Related standards