ISO 2982-1:2013 pdf free
ISO 2982-1:2013 pdf free.Rolling bearings一Accessories一Dimensions for adapter sleeve assemblies and withdrawal sleeves
This part of ISO 2982 specifies:
一 boundary dimensions of adapter sleeves with taper 1:12 and withdrawal sleeves with tapers 1:12 and 1:30 for rolling bearings of a number of dimension series as specified in ISO 15;
一the outside diameter of suitable locknuts;
一distance from bearing small bore face to outer face of locknut;
一distance from bearing small bore face to outer face of bolt head;
一overall length of withdrawal sleeve and bearing ring.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 15, Rolling bearings一Radial bearings一Boundary dimensions, general plan
ISO 2982-2, Rolling bearings一Accessories一Part 2: Dimensions for locknuts and locking devices
ISO 5593, Rolling bearings一Vocabulary
ISO 15241, Rolling bearings一Symbols for physical quantities
For the purposes of this document, the terms and definitions given in ISO 5593 and the following apply.
Dimensions of adapter sleeve assemblies and boundary dimensions of withdrawal sleeves and overall lengths of withdrawal sleeve and bearing ring are given in Table 1, Table 2, Table 3, Table 4 and Table 5.
Thread lengths are not specified but shall be appropriate for securing adapter sleeve with locknut or for withdrawing a rolling bearing on the withdrawal sleeve with locknut. Dimensions of locknuts,lockwashers, and locking clip assemblies for the adapter sleeves are given in ISO 2982-2. The locknuts are also suitable for the dismounting of the withdrawal sleeves.
Dimensions of adapter sleeve assemblies with taper 1:12 are given in Table 1, Table 2 and Table 3. Slot lengths, B6, are not specified but
一shall be at least long enough that lockwasher or locking clip can be installed when rolling bearing,adapter sleeve, and locknut are secured onto a shaft, and
一shall not be longer than 1,3 times thread lengths.ISO 2982-1 pdf download.
