Home>ISO Standards>ISO 11529:2013 pdf free

ISO 11529:2013 pdf free

ISO 11529:2013 pdf free.Milling cutters – Designation
ISO 11529 establishes a designation system for shank-type and bore-type milling cutters of either solid or tipped design or with indexable cutting edges with the purpose of simplifying communication between the users and suppliers of such tools.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3002-1, Basic quantities in cutting and grinding一Part 1: Geometry of the active part of cutting tools一General terms, reference systems, tool and working angles, chip breakers
ISO 3002-3, Basic quantities in cutting and grinding一Part 3: Geometric and kinematic quantities in cutting
3 Summary explanation of the designation system
Shank-type and bore-type milling cutters are designated by codes comprising symbols which identify the important features of the mills.
Extensions to the designation codes to include manufacturer’s or supplier’s information about the milling cutters are described in Clause 5.
No addition to or extension of the designation system given in this International Standard shall be made without consultation with ISO/TC 29 and without its agreement. The designation code shall consist of the following:
Position Definition of designation symbols
1 Number symbol identifying the diameter(see 4.1)
2 Letter symbol identifying the type of milling cutter (see 4.2)
3 Number symbol identifying the number of effective cutting edges (see 4.3)
4 Letter symbol identifying the hand of cutting (see 4.4)
5 Number symbol identifying the cutting-edge angle, Kr (see 4.5)
6 Letter symbol identifying the design of end mill or milling cutter (see 4.6)
7 Number symbol identifying the maximum cutting depth or width, ap (see 4.2)
The diameter of end mills or milling cutters for each letter symbol is shown in the ilustrations in Table 1.
The number symbol identifying the diameter is a one-digit to three-digit number and corresponds to the diameter, in millimetres.ISO 11529 pdf download.

Related standards