BS ISO 6432:2015 pdf free
BS ISO 6432:2015 pdf free.Pneumatic fluid power
BS ISO 6432 establishes a metric series of mounting dimensions required for interchangeability of commonly used pneumatic cylinders for a maximum working pressure of 1 000 kPa (10 bar).
NOTE BS ISO 6432 allows manufacturers freedom of design in metric cylinders and does not restrict technical development but provides basic guidelines.
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3320, Fluid power systems and components 一Cylinder bores and piston rod diameters and area ratios一Metric series
ISO 4393, Fluid power systems and components一Cylinders 一Basic series of piston strokes
ISO 4395, Fluid power systems and components一Cylinder piston rod end types and dimensions
ISO 5598, Fluid power systems and components一Vocabulary
ISO 6099, Fluid power systems and components一Cylinders – – Identification code for mounting dimensions and mounting types
ISO 16030, Pneumatic fluid power一Connections 一Ports and stud ends
The mounting dimensions are given in Tables 2 to 5 and shown in Figures2 to 5.
NOTE 1The sign + after letters means that the stroke is to be added to the actual dimension.
The tolerances of dimensions dependent on stroke included in the tables apply for strokes up to and including 100 mm. If strokes are longer than 100 mm, tolerances should be selected from national standards or by agreement between the manufacturer and user.
This International Standard includes a combination of the following mounting types as described in ISO 6099:
一MR3: Head threaded mounting (see Table 4, Figure 4);
一MP3: Cap fixed eye mounting (see Table 3, Figure 3);
一MS3: Head angle mounting (see Table 5, Figure 5);
一MF8: Head rectangular flange (two hole) mounting (see Table 2, Figure 2).
BS ISO 6432 applies to the following piston rod characteristics:Shouldered or unshouldered male threads.
The dimensions of the piston rod threads shall be chosen in accordance with ISO 4395.
Use the following statement in test reports, catalogues and sales literature when electing to comply with this International Standard:
“Basic, mounting and accessories dimensions of pneumatic cylinders conform to ISO 6432, Pneumatic fluid power一Single rod cylinders, 1 000 kPa (10 bar) series, bores from 8 mm to 25 mm一Basic and mounting dimensions.”BS ISO 6432 pdf download.
