BS ISO 5610-15:2014 pdf free

BS ISO 5610-15:2014 pdf free.Tool holders with rectangular shank for indexable inserts
These tool holders are primarily intended for indexable inserts made of hard metal or other cutting materials to be mounted by clamping and to be used for turning operations.
NOTE The symbols for the dimensions shown in the tables of this part of ISO 5610 and the corresponding preferred symbols of properties defined in ISO/TS 13399-2 and ISO/TS 13399-3 are given in ISO 5610-1:2014,Table A.1.
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 5608:2012, Turning and copying tool holders and cartridges for indexable inserts一Designation
ISO 5610-1:2014, Tool holders with rectangular shank for indexable inserts 一Part 1: General survey,correlation and determination of dimensions
It is not necessary for tool holders to comply with the pictorial representation; only the dimensions given shall be observed.
For determination of dimensions h1, f, and l1, see ISO 5610-1.
For explanation of the designation code for tool holders, see ISO 5608.
NOTE The values of rake angles and inclination angles shown in the figures are recommended values; they can vary according to the application.
Standard design of tool holders with indexable insert shall be mounted in accordance with Table 1.Other types of mounting are at the manufacturer’s discretion or upon agreement. The letter symbol in the designation, symbol 1, shall then be replaced by the respective symbol for the chosen or agreed-upon type of mounting in accordance with ISO 5608.
For the modified type of mounting deviating from Table 1, the relevant indexable insert thickness shall also be considered.
The values for thickness s given in Table 1 apply to indexable inserts without shim and for the standard design of tool holders.
For tool holders for indexable inserts with thicknesses deviating from the specified values, the thickness shall be indicated when ordering or upon delivery (in the handbook).BS ISO 5610-15 pdf download.