BS ISO 21005:2018 pdf free
BS ISO 21005:2018 pdf free.Ships and marine technology一Thermally toughened safety glass panes for windows and side scuttles
This document specifies materials and finish, dimensions for interchangeability, tolerances, parallelism and flatness, testing, marking and designation of thermally toughened safety glass panes for windows complying with ISO 3903 and side scuttles complying with ISO 1751.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 614, Ships and marine technology – Toughened safety glass panes for rectangular windows and side scuttles一Punch method of non-destructive strength testing
ISO 1751, Ships and marine technology一Ships’ side scuttles
ISO 3903, Ships and marine technology一Ships’ ordinary rectangular windows
ISO 6345, Shipbuilding and marine structures一Windows and side scuttles一Vocabulary
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 6345 and the following apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
– ISO Online browsing platform: available at https://www.iso.org/obp
– IEC Electropedia: available at https://www.electropedia.org
3.1 batch of glass panes
quantity of glass panes of the same nominal size and nominal thickness, produced in the same process under consistent controlled conditions
4 Material
Thermally toughened safety glass shall be manufactured of plate glass, either float or polished.
5 Finish
The finished glass pane shall meet the strength requirement of ISO 614. If the finishing method used on the glass pane lowers its strength below the strength required by ISO 614 for the untreated plate, either the finishing method needs to be changed or a thicker glass pane shall be used.
6.1.3 Other dimensions
Dimensions other than those listed in 6.1.1 and 6.1.2 may be agreed on between the parties concerned.
The thickness shall be calculated in accordance with Annex A.
6.2 Edges
All edge work shall be smooth ground and carried out before toughening the glass. See Figure 3.BS ISO 21005 pdf download.