BS ISO 17832:2018 pdf free
BS ISO 17832:2018 pdf free.Non-parallel steel wire and cords for tyre reinforcement
This document specifies the definition and requirements of non parallel steel wire and cords for tyre reinforcement.
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 2859- 1, Sampling procedures for inspection by attributes一Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection
ISO 3951-1, Sampling procedures for inspection by variables一Part 1: Specification for single sampling plans indexed by acceptance quality limit (AQL) for lot-by-lot inspection for a single quality characteristic and a single AQL
ISO 3951-2, Sampling procedures for inspection by variables一Part 2: General specification for single sampling plans indexed by acceptance quality limit (AQL) for lot-by-lot inspection of independent quality characteristics
ISO 3951-3, Sampling procedures for inspection by variables一Part 3: Double sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection
ISO 3951-5, Sampling procedures for inspection by variables一Part 5: Sequential sampling plans indexed by acceptance quality limit (AQL) for inspection by variables (known standard deviation)
For the purposes of this document, the following terms and definitions apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
一IEC Electropedia: available at http://www.electropedia.org/
一ISO Online browsing platform: available at https://www.iso.org/obp
The product shall be packed adequately to ensure safe transportation, handling and correct arrival conditions in the purchaser’s warehouse. In that respect, the necessary precautions to avoid any damage, deterioration, contamination of the product should be taken.
The shelf-life should be 6 months minimum and the humidity should be less than 30 %. A stricter humidity threshold may be agreed upon between the manufacture and the purchaser.
All units are provided with a desiccant and a humidity indicator. Cartons to be shipped can be stored for 6 months inside a warehouse where the combination of temperature and humidity does not lead to condensation. It is recommended to condition the units at ambient temperature before they are opened.
If either shelf-life or humidity are exceeded, adhesion should be retested.BS ISO 17832 pdf download.