BS EN ISO 10750:2018 pdf free

BS EN ISO 10750:2018 pdf free.Footwear – Test method for slide fasteners – Attachment strength of end stops
BS EN ISO 10750 describes a method intended to determine the attachment strength of the top and bottom stops of a slide fastener. The method is applicable to all types of slide fastener for footwear.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 7500-1, Metallic materials一Tensile testing一Part 2: Verification of the force measuring system of the tensile testing machines
ISO 18454, Footwear一Standard atmospheres for conditioning and testing of footwear and components for footwear
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 19952 and the following apply.
3.1 slide fastener
means of securing two flexible materials consisting of interlockable teeth, each attached to one of the opposing edges of two tapes, and movable slider that spans the interlocking teeth which when moved in one direction causes the teeth of one tape to interlock with the teeth of the other tape and when the slider is moved in the opposite direction causes the teeth to disengage
Note 1 to entry: See Figure 1.
4.1 General
This International Standard describes the following methods.
4.2 Method 1一Top stop attachment strength
The slider of a closed fastener is clamped in one jaw of a tensile testing machine and the bottom end of the fastener is clamped in the other jaw. The jaws are then moved apart and the force required to pull the top stops off the fastener is measured.
4.3 Method 2一Bottom stop attachment strength (Slider-stringer method)
The slider of an open fastener is clamped in one jaw of a tensile testing machine and the two free stringer ends are clamped in the other jaw. The jaws are then moved apart and the force required to pull the bottom stops off the fastener is measured.
4.4 Method 3一Bottom stop attachment strength (Stringer-stringer method)
The free stringer ends of an open fastener are fitted into the two jaws of a tensile testing machine. The jaws are then moved apart and the force required to pull the bottom stop off is measured.BS EN ISO 10750 pdf download.